Accessories
Senors & Measurements
Depth Encoder
Depth/Speed (coiled tubing, slickline)
Depth is measured using a quadrature encoder. A quadrature encoder is an up/down counter and can detect the direction of motion. The rate of change is the speed: running in or pulling out.
String Weight (coiled tubing)
Weight can either be measured using a pressure sensor (see Circulating/ Wellhead Pressure) or using an electronic load cell. The electronic load cell will give direct readings of the string weight and is mounted on the injector, replacing the hydraulic load cell.
Electronic Load Cell
Circulating/Wellhead Pressure
These are measured using pressure sensors
with a suitable range (up to 20,000 psi). The
pressure sensors are available with process
connection of G ¼”, ¼” NPT, or WECO union
pressure fitting.
Flow Rate/Flow Total
Flow rates and totals are measured using
either a proximity switch or a magnetic
pickup.
The proximity switch is mounted close to
some rotating part of the pump and will
therefore count the number of revolutions of
the pump. This in turn is interpreted as a
flow volume/rate.
The magnetic pickup is mounted in an insert
on a flow meter. The magnetic pickup will
then produce pulses that are proportional to
the speed of the flow turbine.
Temperature
A complete temperature assembly for any Single Point measurement application. The temperature transmitter is designed to meet common single-point measurement application requirements. This transmitter with HART® protocol can easily be ordered with a variety of sensors (RTDs and thermocouples) and thermowells. The transmitter is provided in a head mount configuration suitable for installation in a wide variety of connection heads and housings.
Temperature Transmitter
Differential Pressure Transmitter
Differential Pressure
With its time‐tested reliability and over 4 million installations, the Rosemount 3051 is more than field proven – it is the Industry Standard. Easy to install on Daniel Senior Orifice meter, suitable for well-testing applications.
Cables & COnnectors
Cables
Connectors
Flow Meter & ANALYsERS
Flow Analyser for Rate & Total
The NuFlo MC-III family of flow analyzers are compatible with the REAM HMI systems. Several flow analyzers can be connected simultaneously. Modbus protocol is used for communication.
Magnetic Pickup Amplifier
Can be used with REAM HMI to measure flow rates and totals from a flow meter or by counting RPM on a rotating shaft.
